Skip to main content

Global Applications

Seven water uses, each mapped to specific models

Each application below lists the models the 2026 catalog covers for it. Where a use needs a specific hydraulic setup or a closed loop, the note under the model list says so.

Application 01

Підвищення тиску для всього будинку

Constant pressure for every tap and shower in one home, holding steady flow when the family is using water at the same time.

Site challenge

Mains pressure drops during peak hours, so upstairs taps, showers and water heaters lose flow.

How we solve it

A permanent magnet VFD booster set holds a steady outlet pressure and runs quietly, sized for a single home rather than a whole block.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

SPS-90 permanent magnet variable frequency booster pump with digital control panel
Typical duty Models for this use: SPS-90, SPS90-3, ICP100A, PB320EA, Z400.
Application 02

Rooftop Tank & Water Tower

Draws water from a rooftop tank or water tower and re-pressurises the house line, so gravity-fed systems keep full flow on every floor.

Site challenge

Water stored in a rooftop tank arrives with low pressure, leaving upper rooms, showers and hot water units short of flow.

How we solve it

A booster set with dry-run protection takes suction from the tank outlet and holds pressure steady as the tank level rises and falls.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

Розумний насос підвищення тиску ICP100F PM VFD з білим корпусом, панеллю дисплея та валом з нержавіючої сталі на білому тлі
Typical duty Models for this use: ICP100F, ICP106F, PYPZ-E.
Application 03

Вілли та багатоповерхові будинки

Multi-point supply for villas and self-built houses with several floors, bathrooms and outdoor taps.

Site challenge

Tall houses with many outlets need even pressure on every floor, but a full plant room is rarely available.

How we solve it

Integrated booster stations with smart VFD control keep pressure constant and fit into a compact utility space or outdoor cabinet.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

Modern villa with a Calliope SG95 booster pump installed at the side of the house, supplying water to several floors
Typical duty Models for this use: SCS90P-3, SCS100P-3, P800-3, PYS-E.
Application 04

Полив саду

Even pressure for drip lines, sprinkler zones and outdoor taps, even when several zones run together.

Site challenge

Sprinkler zones lose pressure when mains supply dips during the evening watering window, leaving dry patches.

How we solve it

Constant pressure control holds each zone at its rated flow, and dry-run protection covers a tank-fed suction line.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

Garden irrigation with sprinklers supplied by a Calliope ICP100F booster pump
Typical duty Models for this use: ICP102-50, high flow model with 2-inch ports; PB320EA.
Application 05

Pipeline Boosting & Circulation

Inline boosting and circulation for hot water lines, taps and fixtures, and short runs where a compact body has to fit the pipework.

Site challenge

Long pipe runs and mixed fixtures lose pressure at the outlet, and a full booster set will not fit the available space.

How we solve it

Pipe-mount and compact multistage boosters raise line pressure close to the point of use, with automatic start and stop on demand.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

SCS100P-3 stainless steel multistage booster pump with black controller, pressure vessel and round control panel
Typical duty Models for this use: SG95, PYS-E, PYPZ-E.
Application 06

Водопостачання кухні

Стабільний тиск для кухонного крана, навіть коли душові та пральні машини працюють одночасно.

Site challenge

The kitchen tap loses pressure whenever another outlet opens, and the pump has to be quiet enough to sit near the living space.

How we solve it

A compact constant-pressure booster holds the kitchen tap at full flow on demand, at whisper-quiet noise beside the living rooms.

Models for this use

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

Modern home kitchen with a Calliope SPS-90 booster pump supplying steady water pressure to the kitchen tap
Typical duty Models for this use: SPS-90.
Application 07

OEM Motors

Permanent magnet motors supplied without a pump wet end, for pump manufacturers and OEM / ODM builds that fit their own hydraulic end.

Site challenge

Pump makers need a matched motor, shaft and control package rather than a complete pump, and the motor has to fit their existing wet end.

How we solve it

P800 and P1500 motors ship with a standard shaft and locating spigot, five speed shifts set on the panel and internal water cooling, so the builder supplies the hydraulic end and the brand.

Models for this use

Motor only — no pump wet end.

Filter the catalog by boosting level, flow, head and application, or send the duty point and the export team will confirm the model.

Двигун з постійними магнітами P800/1500 для виробників насосів
Typical duty Model for this use: P800/1500. Motor only.

Project Support

Share your duty point and site conditions

For engineering and distribution projects we review flow, head, pipe layout and power supply before confirming a boosting level and a control setting.

Choosing By Duty

Choosing a booster by flow and head

The models listed under each use are the ones the 2026 catalog covers for it. Within that shortlist the choice comes down to two figures: the flow the site must deliver and the head needed at the highest or farthest outlet.

Flow is what the site must deliver with the outlets you expect to run at the same time. Head is the lift, plus pipe friction, plus the pressure the outlet needs. Read both figures off the model tables and you land in one of the boosting levels used as a catalog filter: Level 1 covers up to 45 m head and up to 105 L/min, Level 2 reaches 46 to 60 m head for multi-storey villas, and Level 3 delivers up to 500 L/min for large properties with several outlet groups.

The water source changes the installation rather than the size. A booster fed from a rooftop tank or a cistern works on suction lift, so keep the suction pipe short, fit a strainer and a non-return valve, and use dry-run protection for the moments the tank runs low. A booster on a pressurised mains line works on inlet pressure. Both routes draw on the same model shortlists listed above.

The DC range is the separate pipeline boosting indicator. It covers pipe boosting duty rather than whole-house duty: hot water areas, taps and fixtures, and RV or caravan water lines, with automatic start and stop on a 24 V supply.

Готові обговорити специфікацію, напругу та обсяг?

Надішліть цільовий ринок і вимоги. Наша експортна команда підготує індивідуальну комерційну пропозицію для B2B.

Запросити пропозицію
Продажі та експорт
cason@calliopepump.com
Післяпродажне обслуговування
corleone@calliopepump.com
Головний офіс
office@calliopepump.com
Телефон / WhatsApp
+86 178 0591 6566

Ми використовуємо cookie

Необхідні файли cookie забезпечують роботу сайту. Аналітичні файли cookie встановлюються лише після натискання «Прийняти». Якщо ви відхилите, аналітичні файли cookie встановлюватися не будуть. Повідомлення про cookie