- Stałe ciśnienie
- VFD holds steady as demand changes·Fixed-speed rises and falls with every tap.
- Hałas
- VFD permanent magnet motor and hydraulics keep running noise low·Fixed-speed runs full speed around the clock.
- Rotor and materials
- VFD permanent magnets set in the rotor, with stainless impellers and reinforced nylon bodies keeping rust out of the water path·Fixed-speed squirrel cage driven by induced current, often in cast iron bodies that can corrode.
- Speed and energy
- VFD variable up to 5,600 rpm and trims speed as outlets close, so efficiency stays high at part load·Fixed-speed locked near 2,800 rpm, peaking near full load and wasting energy below the design point.
- Power factor
- VFD close to unity, so current draw stays close to useful power·Fixed-speed well below unity, part of the current carries no useful power.
- Starting
- VFD soft start from low speed with no inrush·Fixed-speed direct starting draws several times the rated current.
- Service life and after-sales
- VFD ceramic bearings, stainless impellers and speed control reduce wear and service calls·Fixed-speed standard bearings, constant full-speed load and motor burnouts shorten service intervals.
- Wymiary i zajmowana powierzchnia
- VFD pump, motor and controller sit in one compact body·Fixed-speed needs a larger frame, a tank and a separate switch box.
- Control panel
- VFD panel shows status, mode and protection alarms·Fixed-speed mechanical pressure switch or simple starter with no feedback.
- Automatyczny start i stop
- VFD starts on demand and stops at zero flow·Fixed-speed runs on a timer or pressure switch cycle when water is not needed.
- Voltage tolerance
- VFD wide voltage keeps the pump running on weak supply·Fixed-speed narrow tolerance trips, stalls or damages the motor.
- Positioning and upfront cost
- VFD higher purchase price for the magnets and the integrated drive, and a differentiated smart range for distributors·Fixed-speed lower purchase price, competing almost only on price.
Efficiency, power factor and starting figures are typical for fractional-kW single-phase booster pumps. Values for a specific model are listed in its technical data sheet.